Facilita el desmontaje de los cerrojos Rem 40X, XP-100 & 700
Comprime el muelle principal hasta que se pueda extraer el pasador transversal. El tornillo está empotrado y tiene un hombro para proteger la punta del percutor.
ESPECIFICACIONES: 5½" (14.0cm) de largo. ¾" (19.0mm) de ancho. 1¾" (4.4cm) de alto. Pesa 10 oz. (28.3g). Base de aluminio, tornillo de acero.
Más...
Evaluaciones de clientes para KLEINENDORST FIRING PIN TOOL
Número de evaluaciones: 1
De brownells.com: 1
Evaluación media: 5
REALLY NICE TOOL !!!!!!!!(26/08/2017)
HAVE BEEN USING THIS BENCH-TOOL SINCE THE LATE 1980'S & IT CONTINUES TO DO THE JOB IT WAS DESIGNED TO DO !!!!!! IT ALSO WORKS ON RUGER M77 BOLTS, TO COMPRESS THE F/P SPRING FOR REMOVAL / INSTALL. BUT BE AWARE THAT THE THREADS ON THE RUGER SHROUD WILL ONLY PERMIT JUST A FEW THREADS TO ENTER THE THREADED END OF THE TOOL & STOP TURNING WHEN THE SHROUD STOPS---BE GENTLE !!!!!!!! TOOL IS DESIGNED TO BE CLAMPED IN PADDED JAWS OF A BENCH-VISE / MACHINIST VICE & IS VERY STABLE ONCE CLAMPED INTO PLACE. GIVE IT 2 THUMBS WAY UP-------OOORAH !!!!!!!!!!
N.º de producto: 488002000 KLEINENDORST FIRING PIN TOOL Ref Fabricante: NONE Comprime el muelle principal hasta que se pueda extraer el pasador transversal. El tornillo está empotrado y tiene un hombro para proteger la punta del percutor.
Facilita el desmontaje de los cerrojos Rem 40X, XP-100 & 700
Comprime el muelle principal hasta que se pueda extraer el pasador transversal. El tornillo está empotrado y tiene un hombro para proteger la punta del percutor.
ESPECIFICACIONES: 5½" (14.0cm) de largo. ¾" (19.0mm) de ancho. 1¾" (4.4cm) de alto. Pesa 10 oz. (28.3g). Base de aluminio, tornillo de acero.
Más...
Evaluaciones de clientes para KLEINENDORST FIRING PIN TOOL
Número de evaluaciones: 1
De brownells.com: 1
Evaluación media: 5
REALLY NICE TOOL !!!!!!!!(26/08/2017)
HAVE BEEN USING THIS BENCH-TOOL SINCE THE LATE 1980'S & IT CONTINUES TO DO THE JOB IT WAS DESIGNED TO DO !!!!!! IT ALSO WORKS ON RUGER M77 BOLTS, TO COMPRESS THE F/P SPRING FOR REMOVAL / INSTALL. BUT BE AWARE THAT THE THREADS ON THE RUGER SHROUD WILL ONLY PERMIT JUST A FEW THREADS TO ENTER THE THREADED END OF THE TOOL & STOP TURNING WHEN THE SHROUD STOPS---BE GENTLE !!!!!!!! TOOL IS DESIGNED TO BE CLAMPED IN PADDED JAWS OF A BENCH-VISE / MACHINIST VICE & IS VERY STABLE ONCE CLAMPED INTO PLACE. GIVE IT 2 THUMBS WAY UP-------OOORAH !!!!!!!!!!