A hand operated, carbide cutter easily trims excess material from the bottom barrel lug when fitting custom or factory barrels to 1911 autos. These cutters remove material from the barrel lugs in a parallel fashion, and with the correct height and radius, to help produce the best possible lockup. It is recommended to use the 0.186” cutter first, then progress to the 0.195” cutter if more material needs to be removed. Follow with careful hand fitting to achieve a firm, non-binding barrel-to-slide fit. Start small and check your work often. It is possible, with some slide/barrel combinations, that the 0.195” cutter could remove more material than necessary. Fits all 1911 Auto, Commander, Officer, single and double-stack frames. The 0.186” Lug Cutter, and 0.195” model are available with or without the handle. The handle is also available individually.
Un cortador de carburo operado a mano que recorta fácilmente el material excedente del lug inferior del cañón al ajustar cañones personalizados o de fábrica a autos 1911. Estos cortadores eliminan material de los lugs del cañón de manera paralela, y con la altura y radio correctos, para ayudar a producir el mejor encaje posible. Se recomienda usar primero el cortador de 0.186”, luego pasar al cortador de 0.195” si se necesita eliminar más material. Sigue con un ajuste manual cuidadoso para lograr un ajuste firme y sin fricción entre el cañón y la corredera. Comienza con poco y revisa tu trabajo con frecuencia. Es posible, con algunas combinaciones de corredera/cañón, que el cortador de 0.195” pueda eliminar más material del necesario. Se adapta a todos los modelos 1911 Auto, Commander, Officer, marcos de un solo y doble apilamiento. El cortador de lugs de 0.186” y el modelo de 0.195” están disponibles con o sin el mango. El mango también está disponible de manera individual.