MIL-STD 1913 Picatinny rail is machined from lightweight Tennalum® 7068 alloy that gives the same strength as steel with only ¹/³ the weight. All contact surfaces are stress relieved and pre-ground before final machining to exact MIL-STD 1913 dimensions. Integral recoil lug and elongated mounting screws let you position the rail so the lug will bear properly against the receiver to prevent the rail from moving even under aggressive recoil. Built in 20 MOA of elevation for extended long-range shooting. All surfaces are fully chamfered, with extra clearance over the ejection port.
SPECS: Tennalum 7068 alloy, hardcoat anodized, matte black finish. Instructions and 6-48 mounting screws included. Short Action (SA) – 6½" (16.5 cm) long, .380” (9.4 mm) high at front ring, 2.3 oz. (.65g) wt.
El riel Picatinny MIL-STD 1913 está mecanizado de la ligera aleación Tennalum® 7068, que ofrece la misma resistencia que el acero con solo ¹/³ del peso. Todas las superficies de contacto están aliviadas de estrés y pre-molidas antes del mecanizado final a las dimensiones exactas del MIL-STD 1913. El espárrago de retroceso integral y los tornillos de montaje alargados te permiten posicionar el riel de manera que el espárrago soporte adecuadamente contra el receptor, evitando que el riel se mueva incluso bajo un retroceso agresivo. Construido con 20 MOA de elevación para disparos a larga distancia. Todas las superficies están completamente biseladas, con un extra de espacio sobre el puerto de eyección.
ESPECIFICACIONES: Aleación Tennalum 7068, anodizado duro, acabado negro mate. Instrucciones y tornillos de montaje 6-48 incluidos. Acción Corta (SA) – 6½" (16.5 cm) de largo, .380” (9.4 mm) de alto en el anillo frontal, 2.3 oz. (.65g) de peso.