Material: 7075 Aluminum Coating: Matte Black Hardcoat Overall Length: 1.780" Overall Width: 1.1" Mounting Hardware: (2) 6-32 Flat Head Screws, (1) 6-32 X 3/16 Set Screw Red Dot Fitment: Trijicon RMR, Holosun HS507C This mounts fits: Baby Desert Eagle (Post 2006) EAA Witness Elite Match This mount does not fit: Rock Island 1911s Simply remove the rear sight on your gun and replace it with our mount in order to mount your Trijicon RMR red dot sight. No alterations are required. You can take our mount off and replace your rear sight at any time. Mounting hardware included. Installation Instructions Remove the rear sight* Install the EGW Sight Mount in the dovetail Tighten set screw (if applicable) Place the red dot sight on the EGW Sight Mount (placing a small piece of paper between the red dot sight and the sight mount will make for easier removal and will keep Loctite off of the red dot sight.) Apply blue Loctite to the provided mounting screws Torque mounting screws to 15in/lbs 2 Flat Head Cap Screws - Provided for Trijicon RMR The screws that are included with this mount require a 5/64'' allen wrench for installation.
Material: Aluminio 7075 Recubrimiento: Negro Mate Duro Longitud Total: 1.780" Ancho Total: 1.1" Hardware de Montaje: (2) Tornillos de Cabeza Plana 6-32, (1) Tornillo de Fijación 6-32 X 3/16 Ajuste para Punto Rojo: Trijicon RMR, Holosun HS507C Este soporte es compatible con: Baby Desert Eagle (Post 2006) EAA Witness Elite Match Este soporte no es compatible con: Rock Island 1911s Simplemente quita la mira trasera de tu arma y reemplázala con nuestro soporte para montar tu mira de punto rojo Trijicon RMR. No se requieren alteraciones. Puedes quitar nuestro soporte y volver a colocar tu mira trasera en cualquier momento. Hardware de montaje incluido. Instrucciones de Instalación Quita la mira trasera* Instala el Soporte de Mira EGW en la cola de milano Aprieta el tornillo de fijación (si corresponde) Coloca la mira de punto rojo en el Soporte de Mira EGW (colocar un pequeño trozo de papel entre la mira de punto rojo y el soporte de mira facilitará la remoción y evitará que el Loctite toque la mira de punto rojo.) Aplica Loctite azul a los tornillos de montaje proporcionados Aprieta los tornillos de montaje a 15in/lbs 2 Tornillos de Cabeza Plana - Proporcionados para Trijicon RMR Los tornillos incluidos con este soporte requieren una llave allen de 5/64'' para la instalación.