Lee Bullet Sizing Kits are the fastest and easiest way to size cast bullets. Standard 7-8x14" threads fit any single stage reloading press. Bullets are pushed through the sizing die nose first, so no special nose punches are needed. Gas checks are automatically seated and crimped in place. Sized bullets are captured in the special container. Complete for one size. Press and bullet lubricant are sold separately. Special note: Intended for use on single stage presses only. The push through Punch is used in place of a Shell Holder in the Ram. Lee does not make top punches for molds. With the use of this kit, a top punch is not necessary. To crimp gas checks with the lube and size kit, first lubricate the bullets with liquid alox, push a gas check on the base of the bullet and set the bullet on the punch. When the bullet is pushed through the sizing die, the bullet will be sized, and the gas check will be crimped on. For cast bullets, you want to select a sizing kit to be .001" larger than groove diameter.
Los Kits de Tamaño de Balas Lee son la forma más rápida y fácil de dimensionar balas fundidas. Las roscas estándar de 7-8x14" se adaptan a cualquier prensa de recarga de un solo etapa. Las balas se empujan a través del troquel de tamaño con la punta primero, por lo que no se necesitan punzones especiales. Los gas checks se asientan y se ajustan automáticamente en su lugar. Las balas dimensionadas se capturan en el contenedor especial. Completo para un tamaño. El lubricante para prensa y balas se venden por separado. Nota especial: destinado para su uso solo en prensas de un solo etapa. El punzón de empuje se utiliza en lugar de un soporte de vaina en el ram. Lee no fabrica punzones superiores para moldes. Con el uso de este kit, no es necesario un punzón superior. Para ajustar gas checks con el kit de lubricación y tamaño, primero lubrica las balas con alox líquido, coloca un gas check en la base de la bala y coloca la bala en el punzón. Cuando la bala se empuje a través del troquel de tamaño, la bala será dimensionada y el gas check se ajustará. Para balas fundidas, debes seleccionar un kit de tamaño que sea .001" más grande que el diámetro de la estría.