O-1 OIL HARDENING DRILL ROD ROUND Carbon - .95% Manganese - 1.20% Silicon - .25% For ¼" round and larger, we carry oil hardening drill rod rather than water hardening. The O-1 in this size range is characterized by good machineability, smooth finish as well as superior dimensional stability and excellent hardening characteristics. We recommend it for use in dies, tools, parts, and punches. Excellent for general use in the shop. HARDENING: Heat slowly to 1475° F. - 1525° F. If a controlled furnace is not available, use 1500° Tempilaq. Hold at this temperature for a few seconds then quench in a light quenching oil. TEMPERING: Temper immediately. The following hardness table is for a one hour draw after oil quenching at 1500° F. Degrees F. Rockwell C Hardness As Hardened 63 - 65 300° 63 - 64 400° 61 - 62 500° 58 - 60 600° 54 - 56 700° 51 - 53 800° 46 - 48 900° 43 - 45
SPECS: Rods are 18" in length.
O-1 OIL HARDENING DRILL ROD ROUND Carbono - .95% Manganeso - 1.20% Silicio - .25% Para varillas redondas de ¼" y más grandes, ofrecemos varillas de perforación de endurecimiento por aceite en lugar de endurecimiento por agua. El O-1 en este rango de tamaño se caracteriza por su buena maquinabilidad, acabado suave, así como por su superior estabilidad dimensional y excelentes características de endurecimiento. Lo recomendamos para su uso en matrices, herramientas, piezas y punzones. Excelente para uso general en el taller. ENDURECIMIENTO: Calienta lentamente a 1475° F. - 1525° F. Si no tienes un horno controlado disponible, utiliza 1500° Tempilaq. Mantén esta temperatura durante unos segundos y luego enfría en un aceite de enfriamiento ligero. TEMPLE: Temple inmediatamente. La siguiente tabla de dureza es para un tratamiento de una hora después del enfriamiento en aceite a 1500° F. Grados F. Dureza Rockwell C Dureza Al Endurecer 63 - 65 300° 63 - 64 400° 61 - 62 500° 58 - 60 600° 54 - 56 700° 51 - 53 800° 46 - 48 900° 43 - 45
ESPECIFICACIONES: Las varillas tienen 18" de longitud.