A quick and easy method to install choke tubes using a lathe (can be done by hand, however, a lathe gives superior results). Tap and reamer are precision ground from high speed steel and use the same interchangeable pilot bushings. Reamer has an enhanced end relief that provides a faster cut. Pilot bushings are available in diameter increments of .001", and are 2" long for accurate bore alignment. Factory instructions are included. Note: Read and understand the installation requirements on page 62 before proceeding. For best results, remove any existing choke with the Angle Blade Expanding Choke Reamer prior to using the Loon Lake Choke reamer. Click here for proper installation requirements.Uses the same tap and bushings as Win-Choke, requires a different reamer to position threads in a different location. Barrels threaded to this system accept Rem-Choke-style and Remington factory tubes.
Un método rápido y fácil para instalar tubos de choke utilizando un torno (se puede hacer a mano, sin embargo, un torno ofrece resultados superiores). El macho y el reamer están fabricados con acero de alta velocidad y utilizan los mismos casquillos piloto intercambiables. El reamer tiene un aliviado en el extremo mejorado que proporciona un corte más rápido. Los casquillos piloto están disponibles en incrementos de diámetro de .001" y tienen 2" de largo para una alineación precisa del cañón. Se incluyen instrucciones de fábrica. Nota: Lee y comprende los requisitos de instalación en la página 62 antes de proceder. Para obtener los mejores resultados, retira cualquier choke existente con el reamer de expansión de cuchilla angular antes de usar el reamer de Loon Lake. Haz clic aquí para los requisitos de instalación adecuados. Utiliza el mismo macho y casquillos que Win-Choke, requiere un reamer diferente para posicionar las roscas en una ubicación diferente. Los cañones roscados para este sistema aceptan tubos al estilo Rem-Choke y tubos de fábrica Remington.