Trim the case once—never trim again! The X-Sizer Die looks like a regular Full Length Sizer Die. Inside, the die features a specially designed mandrel with an expander ball and decapping pin attached. The mandrel is what the X-Die® is all about. The patented X-Sizer Die eliminates the need for repeated trimming after an initial trim of .020” off the maximum case length to standardize the case. The X-Die doesn’t shorten the length of the case: the mandrel reduces the growth rate as the case grows as a result of the case mouth-contacting the mandrel during sizing. Because of an extremely close tolerance between the mandrel and die neck wall, the neck wall of the case does not thicken as the case length is pushed back. Cases repeatedly sized in the X-Die will initially grow a few thousandths of an inch, then stabilize below the maximum case length with no discernable loss of accuracy or case life.
¡Recorta la vaina una vez y nunca más tendrás que recortarla! El X-Sizer Die se parece a un Die de Sizer de Longitud Completa normal. En su interior, el die cuenta con un mandril especialmente diseñado con una bola de expansión y un pin de descompresión adjunto. El mandril es la clave del X-Die®. El X-Sizer Die patentado elimina la necesidad de recortes repetidos después de un recorte inicial de .020” de la longitud máxima de la vaina para estandarizarla. El X-Die no acorta la longitud de la vaina: el mandril reduce la tasa de crecimiento a medida que la vaina se expande debido al contacto de la boca de la vaina con el mandril durante el dimensionado. Debido a una tolerancia extremadamente ajustada entre el mandril y la pared del cuello del die, la pared del cuello de la vaina no se engrosa a medida que se empuja la longitud de la vaina hacia atrás. Las vainas dimensionadas repetidamente en el X-Die inicialmente crecerán unos pocos miles de pulgadas, luego se estabilizarán por debajo de la longitud máxima de la vaina sin pérdida discernible de precisión o vida de la vaina.